CNC Router SPEED ADJUST on MACH 3
- Details
- Category: CNC ROUTER
- Published on Wednesday, 15 September 2010 16:04
- Hits: 5026
CNC Router X-AXIS:
CNC Router Y-AXIS:
CNC Router Z-AXIS:
install CNC software problem.
- Details
- Category: CNC ROUTER
- Published on Friday, 29 April 2011 03:00
- Hits: 4395
Ask:
I turn on machine and select Mach mill 3 and the motor starts straight away and RESET emergency stop flashes and will not shut off unless I select the offline option or until I shut down the machine,or if I disconnect the serial connection cable from the control unit, have gone through system and can't find any conflicts in the hardware.
Answer:
Please read the manual, page:4-7:
Your model is “NO.2”.
MACH directory, click back. “NO.2”, choose corresponding models and install it machine.