What to do if the E300 electric creaser 19'' does not start?

Details

Category: Creasing Machine

Published on Monday, 26 March 2012 01:21

Written by shichang ding

Hits: 3976

Q： I bought the E300 Electric creaser 19'' machine from you but the machine does not work when I open the switch. Only the light is on .

A: Some of the machine part may be loosen during shipping. You can try to repair the machine by following steps:

Step 1: Unlock the two screws and open the worktable cover of the machine.

Step 2: Check if the steel bar is out of its original position.

Step 3: If yes, please loose the upper screws to adjust the steel bar to correct position. Then, lock the screws.

Step 4: Check if the sping is out of its original position.

Step 5: If yes, push a sheet under the spring and the spring will goto the correct position.

Step 6: After the steel bar is in its correct position, if it can not rotate smoothly, loose the two screws a little to release some pressure.

7. If all of the above is adjusted and the machine can not work still . Check if the motor and the wire are connecting well.